|
|
Rubber Insulated Machine
Mounts
|
|
||||||
|
|
Vibro-Leveler Mounts:
Simple in design and construction, each Vibro Leveler has an inner cylinder with attached stud. These are insulated from the outer shell by a wall of mechanically bonded rubber. Safe and Smooth Operation Ten shelf-standard sizes can meet your specific requirements. Available in capacities from 10 to 1,000 pounds, Vibro-Levelers provide an ample safety margin. Even when overloaded to destruction, they only permit a drop of less than one-half inch. Bushings, Inc. recommends Vibro-Levelers both for new and existing machines. Typical applications include blowers, compressors, punch presses, vacuum pumps, hydraulic presses, jig borers, screw machines, snag grinders, and other machinery. Installation Usually, Vibro-Levelers are installed under a machine. Simply raise or tilt the machine to allow a Vibro-Leveler to be slipped under the base. Insert its stud into the hold-down bolt hole in the base of the machine. To level the machine, turn the lower nut to hold it in position. Then lock the upper nut to hold it in position Although seldom required, Vibro-Levelers feature hold-down bolt holes in the base to secure them to the floor when necessary. While a typical installation requires four Vibro-Levers, more or less can be used depending on the points of suspension. Once the total weight of the machine is established, refer to the specification table shown here. The combined capacity of the number of mountings should equal or exceed the total weight of the machine to be supported. If the machine to be supported is not symmetrical so that there would be considerably more weight on one end than the other, the mountings on the heavier end must be of correspondingly greater capacity.
To order or request
additional information for all products:
home
| marine & industrial engine mounts |
|||||||
